Turn a task handoff into a Bolt device action
Moving a task into a section can mark the moment for a device signal. Notis checks connectivity first, then sets the digital pin to the level in your instruction.
Trigger
Task Moved to Section
Triggers when a task is moved to a section in a project.
Action
Bolt IoT Digital Write
Tool to set a digital pin high or low on a specified bolt device. use when controlling actuators or leds via digital output.
Why this helps
A section change can require a device action, and switching tools to send it creates avoidable delay.
- Tie a project handoff to a defined digital output.
- Check Bolt connectivity before sending the command.
- Keep run reports with the channel you already use.
Setup
Build it in a few focused steps.
- 1Connect Asana and Bolt IoT once in the Notis portal.
- 2Create an automation in Automations, New Automation, with a name and prompt.
- 3Tell Notis which section change should trigger an online check and which Bolt device and digital pin to set high or low.
- 4Pick the Asana Task Moved to Section trigger and choose where run reports go.
- 5Test with one real task move and a safe, known output.
Questions about this workflow
Can this set either high or low?
Yes. State the desired level and pin in your instruction. The action sets a digital pin high or low.
What happens if the device is offline?
The prompt should direct Notis to check status before sending the command and report when the device is not online.
When this happens · Trigger
Do this · Action
Supported Triggers and Actions
Notis builds workflows that link Asana to Bolt iot. A trigger fires from one place; an action lands in another.
Asana triggers
Bolt iot actions
Recurring trigger
Notis starts this workflow on a schedule, such as daily, weekly, or during business hours.
Analog Read
Tool to read the analog value from a specified pin on a bolt device. use when you need sensor readings (0–1023) after confirming the device is online.
Webhook trigger
Notis starts this workflow when an external tool or custom backend sends an HTTP request.
Bolt IoT Digital Write
Tool to set a digital pin high or low on a specified bolt device. use when controlling actuators or leds via digital output.
Attachment Added to Task
Triggers when an attachment is added to a task.
Check Bolt device online status
Tool to check whether a specified bolt device is online. use when you need to verify device connectivity before sending commands (e.g., control signals). example: 'check if device bolt1234567 is online.'
New Comment on Task
Triggers when a comment is added to a task in a project.
Bolt IoT Digital Write
Tool to set a digital pin high or low on a specified bolt device. use when controlling actuators or leds via digital output.
New Task Created
Triggers when a new task is created in a project.
Bolt IoT Serial Read
Tool to read incoming serial data from a bolt device. use when you've initialized uart with serialbegin and need to retrieve serial data.
Task Moved to Section
Triggers when a task is moved to a section in a project.
Bolt IoT Serial Write
Tool to send serial data to a bolt device. use when you need to transmit ascii data over uart after initializing uart with serialbegin.
Tag Added to Task
Triggers when a tag is added to a task. Note: Asana's event structure is inverted for tag events — the resource is the task and the parent is the tag. So parent.gid gives the tag GID.
Bolt IoT Serial Write & Read
Tool to send serial data and read the response on a bolt device. use when you need to transmit ascii data over uart and capture its reply immediately.
Task Updated
Triggers when a task is updated in a project.
Connect any two apps with Notis in the middle.
Asana and Bolt iot, or any other combination from 1,000+ integrations.
When this happens · Trigger
Do this · Action
Save your first hour today.
7-day trial of any paid plan, with 20$ of usage included.
No card. Works with personal or business Bolt iot.