Bring device connectivity into incident triage
Check the relevant device as an incident opens, so the team can focus on the right next step.
Trigger
Webhook received
Notis starts this workflow when an external tool or custom backend sends an HTTP request.
Action
Check Bolt device online status
Tool to check whether a specified bolt device is online. use when you need to verify device connectivity before sending commands (e.g., control signals). example: 'check if device bolt1234567 is online.'
Why this helps
Incident triage slows down when people have to pause and manually verify whether hardware is reachable.
- Add a connectivity check at incident intake
- Reduce manual status chasing during triage
- Give the next owner a clear starting point
Setup
Build it in a few focused steps.
- 1Connect OpenAI and Bolt IoT to Notis once through the portal.
- 2Create an automation with one instruction to check the specified Bolt device's online status and report the result.
- 3Choose an incoming webhook trigger and the channel for run reports.
- 4Configure your incident system to call the webhook when an incident opens, then test with one real incident.
Questions about this workflow
Does this decide whether an incident is resolved?
No. It reports device connectivity as one useful triage signal.
Can an incident system start it?
Yes, if your system can send an HTTP request to the Notis webhook.
When this happens · Trigger
Do this · Action
Supported Triggers and Actions
Notis builds workflows that link OpenAI to Bolt iot. A trigger fires from one place; an action lands in another.
OpenAI triggers
Bolt iot actions
Recurring trigger
Notis starts this workflow on a schedule, such as daily, weekly, or during business hours.
Analog Read
Tool to read the analog value from a specified pin on a bolt device. use when you need sensor readings (0–1023) after confirming the device is online.
Webhook trigger
Notis starts this workflow when an external tool or custom backend sends an HTTP request.
Bolt IoT Digital Write
Tool to set a digital pin high or low on a specified bolt device. use when controlling actuators or leds via digital output.
Check Bolt device online status
Tool to check whether a specified bolt device is online. use when you need to verify device connectivity before sending commands (e.g., control signals). example: 'check if device bolt1234567 is online.'
Bolt IoT Digital Write
Tool to set a digital pin high or low on a specified bolt device. use when controlling actuators or leds via digital output.
Bolt IoT Serial Read
Tool to read incoming serial data from a bolt device. use when you've initialized uart with serialbegin and need to retrieve serial data.
Bolt IoT Serial Write
Tool to send serial data to a bolt device. use when you need to transmit ascii data over uart after initializing uart with serialbegin.
Bolt IoT Serial Write & Read
Tool to send serial data and read the response on a bolt device. use when you need to transmit ascii data over uart and capture its reply immediately.
Connect any two apps with Notis in the middle.
OpenAI and Bolt iot, or any other combination from 1,000+ integrations.
When this happens · Trigger
Do this · Action
Save your first hour today.
7-day trial of any paid plan, with 20$ of usage included.
No card. Works with personal or business Bolt iot.