Close the workday with one sensor reading
Finish a device-related workday with a consistent value to carry into tomorrow's review.
Trigger
Recurring schedule
Notis starts this workflow on a schedule, such as daily, weekly, or during business hours.
Action
Analog Read
Tool to read the analog value from a specified pin on a bolt device. use when you need sensor readings (0–1023) after confirming the device is online.
Why this helps
A closing check is easy to skip when the last part of the day is already full of wrap-up tasks.
- Make a closing reading part of a repeatable routine
- Reduce forgotten end-of-day checks
- Keep a value ready for tomorrow's context
Setup
Build it in a few focused steps.
- 1Connect OpenAI and Bolt IoT to Notis once through the portal.
- 2Create an automation called Closing-time sensor reading.
- 3Write one instruction asking Notis to read the specified analog pin on an online Bolt device and report the value.
- 4Choose a workday closing schedule and run-report channel, then test with one real reading.
Questions about this workflow
Can this run only at the end of my workday?
Choose a recurring schedule that matches your workday closing time.
What happens if the device is offline?
The requested sensor read depends on an online device; use an online status check workflow if you need a separate connectivity check.
When this happens · Trigger
Do this · Action
Supported Triggers and Actions
Notis builds workflows that link OpenAI to Bolt iot. A trigger fires from one place; an action lands in another.
OpenAI triggers
Bolt iot actions
Recurring trigger
Notis starts this workflow on a schedule, such as daily, weekly, or during business hours.
Analog Read
Tool to read the analog value from a specified pin on a bolt device. use when you need sensor readings (0–1023) after confirming the device is online.
Webhook trigger
Notis starts this workflow when an external tool or custom backend sends an HTTP request.
Bolt IoT Digital Write
Tool to set a digital pin high or low on a specified bolt device. use when controlling actuators or leds via digital output.
Check Bolt device online status
Tool to check whether a specified bolt device is online. use when you need to verify device connectivity before sending commands (e.g., control signals). example: 'check if device bolt1234567 is online.'
Bolt IoT Digital Write
Tool to set a digital pin high or low on a specified bolt device. use when controlling actuators or leds via digital output.
Bolt IoT Serial Read
Tool to read incoming serial data from a bolt device. use when you've initialized uart with serialbegin and need to retrieve serial data.
Bolt IoT Serial Write
Tool to send serial data to a bolt device. use when you need to transmit ascii data over uart after initializing uart with serialbegin.
Bolt IoT Serial Write & Read
Tool to send serial data and read the response on a bolt device. use when you need to transmit ascii data over uart and capture its reply immediately.
Connect any two apps with Notis in the middle.
OpenAI and Bolt iot, or any other combination from 1,000+ integrations.
When this happens · Trigger
Do this · Action
Save your first hour today.
7-day trial of any paid plan, with 20$ of usage included.
No card. Works with personal or business Bolt iot.