Leave a clear device status for tomorrow
Close the day with a small check that makes the next morning easier to pick up.
Trigger
Recurring schedule
Notis starts this workflow on a schedule, such as daily, weekly, or during business hours.
Action
Check Bolt device online status
Tool to check whether a specified bolt device is online. use when you need to verify device connectivity before sending commands (e.g., control signals). example: 'check if device bolt1234567 is online.'
Why this helps
Unresolved hardware uncertainty can linger into the next day and compete with more important work.
- Surface connectivity status at a consistent time
- Start tomorrow with less uncertainty
- Keep after-hours review short
Setup
Build it in a few focused steps.
- 1Connect OpenAI and Bolt IoT to Notis once through the portal.
- 2Create an automation called After-hours device status.
- 3Write one prompt asking Notis to check a specified Bolt device and report whether it is online.
- 4Choose an evening schedule and run-report channel, then test with one real device.
Questions about this workflow
Does this repair a device if it is offline?
No. It checks status and reports it so you can decide on follow-up.
Can I choose when the report arrives?
Yes. Select an evening recurring schedule and a channel for run reports.
When this happens · Trigger
Do this · Action
Supported Triggers and Actions
Notis builds workflows that link OpenAI to Bolt iot. A trigger fires from one place; an action lands in another.
OpenAI triggers
Bolt iot actions
Recurring trigger
Notis starts this workflow on a schedule, such as daily, weekly, or during business hours.
Analog Read
Tool to read the analog value from a specified pin on a bolt device. use when you need sensor readings (0–1023) after confirming the device is online.
Webhook trigger
Notis starts this workflow when an external tool or custom backend sends an HTTP request.
Bolt IoT Digital Write
Tool to set a digital pin high or low on a specified bolt device. use when controlling actuators or leds via digital output.
Check Bolt device online status
Tool to check whether a specified bolt device is online. use when you need to verify device connectivity before sending commands (e.g., control signals). example: 'check if device bolt1234567 is online.'
Bolt IoT Digital Write
Tool to set a digital pin high or low on a specified bolt device. use when controlling actuators or leds via digital output.
Bolt IoT Serial Read
Tool to read incoming serial data from a bolt device. use when you've initialized uart with serialbegin and need to retrieve serial data.
Bolt IoT Serial Write
Tool to send serial data to a bolt device. use when you need to transmit ascii data over uart after initializing uart with serialbegin.
Bolt IoT Serial Write & Read
Tool to send serial data and read the response on a bolt device. use when you need to transmit ascii data over uart and capture its reply immediately.
Connect any two apps with Notis in the middle.
OpenAI and Bolt iot, or any other combination from 1,000+ integrations.
When this happens · Trigger
Do this · Action
Save your first hour today.
7-day trial of any paid plan, with 20$ of usage included.
No card. Works with personal or business Bolt iot.