Send a recurring Bolt serial command
Automate routine device instructions without another calendar reminder.
Trigger
Recurring schedule
Notis starts this workflow on a schedule, such as daily, weekly, or during business hours.
Action
Bolt IoT Serial Write
Tool to send serial data to a bolt device. use when you need to transmit ascii data over uart after initializing uart with serialbegin.
Why this helps
Repeated device commands are easy to skip when they depend on manual routines.
- Automate routine commands
- Keep timing consistent
- Reduce repetitive work
Setup
Build it in a few focused steps.
- 1Connect Coda and Bolt iot once in the Notis portal.
- 2Create an automation with the exact ASCII command and target device.
- 3Pick a Notis cron trigger and set the schedule.
- 4Choose where reports go and test with one real scheduled run.
Questions about this workflow
What is sent to the device?
The workflow sends the ASCII data specified in your instruction over UART.
Does the device need UART setup?
Yes. Initialize UART with serialbegin before the scheduled command runs.
When this happens · Trigger
Do this · Action
Supported Triggers and Actions
Notis builds workflows that link Coda to Bolt iot. A trigger fires from one place; an action lands in another.
Coda triggers
Bolt iot actions
Recurring trigger
Notis starts this workflow on a schedule, such as daily, weekly, or during business hours.
Analog Read
Tool to read the analog value from a specified pin on a bolt device. use when you need sensor readings (0–1023) after confirming the device is online.
Webhook trigger
Notis starts this workflow when an external tool or custom backend sends an HTTP request.
Bolt IoT Digital Write
Tool to set a digital pin high or low on a specified bolt device. use when controlling actuators or leds via digital output.
Coda Document Deleted Trigger
Triggers when a Coda document is deleted.
Check Bolt device online status
Tool to check whether a specified bolt device is online. use when you need to verify device connectivity before sending commands (e.g., control signals). example: 'check if device bolt1234567 is online.'
New Coda Document Trigger
Triggers when a new Coda document is created.
Bolt IoT Digital Write
Tool to set a digital pin high or low on a specified bolt device. use when controlling actuators or leds via digital output.
New Coda Page Trigger
Triggers when a new page is added to a Coda document.
Bolt IoT Serial Read
Tool to read incoming serial data from a bolt device. use when you've initialized uart with serialbegin and need to retrieve serial data.
Specific Coda Page Updated Trigger
Triggers when a specific page within a Coda document is updated.
Bolt IoT Serial Write
Tool to send serial data to a bolt device. use when you need to transmit ascii data over uart after initializing uart with serialbegin.
Bolt IoT Serial Write & Read
Tool to send serial data and read the response on a bolt device. use when you need to transmit ascii data over uart and capture its reply immediately.
Connect any two apps with Notis in the middle.
Coda and Bolt iot, or any other combination from 1,000+ integrations.
When this happens · Trigger
Do this · Action
Save your first hour today.
7-day trial of any paid plan, with 20$ of usage included.
No card. Works with personal or business Bolt iot.