Change a Bolt output when ClickUp status changes
Let task status drive the next physical signal.
Trigger
Task Status Updated
Triggers when a task's status changes. `changes[]` carries `StatusChange` entries only — ClickUp pre-filters server-side by event type. Lower traffic than subscribing to `CLICKUP_TASK_UPDATED` and pattern-matching `StatusChange`.
Action
Bolt IoT Digital Write
Tool to set a digital pin high or low on a specified bolt device. use when controlling actuators or leds via digital output.
Why this helps
Status changes often require a separate manual device action.
- Turn workflow states into signals
- Avoid duplicate updates
- Give teams visible physical feedback
Setup
Build it in a few focused steps.
- 1Connect ClickUp and Bolt iot in Notis once.
- 2Create the automation and give it a clear name.
- 3Tell Notis to set the required Bolt digital pin high or low based on the new task status.
- 4Pick ClickUp Task Status Updated as the trigger.
- 5Select a report channel and test with one status change.
Questions about this workflow
Can I define different outputs for statuses?
Describe the status rules and pin behavior in the automation instruction.
Which pins are supported?
Use a valid digital pin for the specified Bolt device.
When this happens · Trigger
Do this · Action
Supported Triggers and Actions
Notis builds workflows that link Clickup to Bolt iot. A trigger fires from one place; an action lands in another.
Clickup triggers
Bolt iot actions
Recurring trigger
Notis starts this workflow on a schedule, such as daily, weekly, or during business hours.
Analog Read
Tool to read the analog value from a specified pin on a bolt device. use when you need sensor readings (0–1023) after confirming the device is online.
Webhook trigger
Notis starts this workflow when an external tool or custom backend sends an HTTP request.
Bolt IoT Digital Write
Tool to set a digital pin high or low on a specified bolt device. use when controlling actuators or leds via digital output.
Folder Created
Triggers when a new Folder is created.
Check Bolt device online status
Tool to check whether a specified bolt device is online. use when you need to verify device connectivity before sending commands (e.g., control signals). example: 'check if device bolt1234567 is online.'
Folder Deleted
Triggers when a Folder is deleted.
Bolt IoT Digital Write
Tool to set a digital pin high or low on a specified bolt device. use when controlling actuators or leds via digital output.
Folder Updated
Triggers when a Folder is updated (renamed, content edited, etc.).
Bolt IoT Serial Read
Tool to read incoming serial data from a bolt device. use when you've initialized uart with serialbegin and need to retrieve serial data.
List Created
Triggers when a new List is created.
Bolt IoT Serial Write
Tool to send serial data to a bolt device. use when you need to transmit ascii data over uart after initializing uart with serialbegin.
List Deleted
Triggers when a List is deleted.
Bolt IoT Serial Write & Read
Tool to send serial data and read the response on a bolt device. use when you need to transmit ascii data over uart and capture its reply immediately.
List Updated
Triggers when a List is updated (renamed, content edited, etc.).
Connect any two apps with Notis in the middle.
Clickup and Bolt iot, or any other combination from 1,000+ integrations.
When this happens · Trigger
Do this · Action
Save your first hour today.
7-day trial of any paid plan, with 20$ of usage included.
No card. Works with personal or business Bolt iot.