Schedule a Bolt digital output state
Make a planned output change happen on time, with a connectivity check before the pin is set.
Trigger
Recurring schedule
Notis starts this workflow on a schedule, such as daily, weekly, or during business hours.
Action
Bolt IoT Digital Write
Why this helps
A routine output change can slip when it depends on someone remembering to operate a device manually.
- Run a planned digital output change at a recurring time.
- Require an explicit HIGH or LOW state in the automation prompt.
- Check that the device is online before sending the write.
Setup
Build it in a few focused steps.
- 1Connect Bolt IoT once in the Notis portal.
- 2Create an automation from any channel or Automations, New Automation in the portal.
- 3Tell Notis: on each run, check the specified Bolt device online and set the specified pin to the explicitly requested HIGH or LOW state only if online.
- 4Choose the notis_cron trigger and set the recurring schedule.
- 5Choose where run reports should go and test with one safe output and real device.
Questions about this workflow
Will Notis decide which state is safe?
No. State the intended HIGH or LOW output explicitly in the prompt and verify it is appropriate for your device.
Does the schedule control the device if it is offline?
The workflow should check online status first and report the unavailable device without attempting the write.
When this happens · Trigger
Do this · Action
Supported Triggers and Actions
Notis builds workflows that link AnyDB to Bolt iot. A trigger fires from one place; an action lands in another.
AnyDB triggers
Bolt iot actions
Recurring trigger
Notis starts this workflow on a schedule, such as daily, weekly, or during business hours.
Analog Read
Reads the analog value from a device pin.
Webhook trigger
Notis starts this workflow when an external tool or custom backend sends an HTTP request.
Check Bolt device online status
Checks whether a device is online.
Bolt IoT Digital Write
Sets a device’s digital pin to HIGH or LOW.
Bolt IoT Serial Read
Reads incoming serial data from a device.
Bolt IoT Serial Write
Sends serial data to a device.
Bolt IoT Serial Write & Read
Sends serial data to a device and reads its reply.
Connect any two apps with Notis in the middle.
AnyDB and Bolt iot, or any other combination from 1,000+ integrations.
When this happens · Trigger
Do this · Action
Save your first hour today.
7-day trial of any paid plan, with 20$ of usage included.
No card. Works with personal or business Bolt iot.