Send an approved Bolt output command from AnyDB
Keep a clear request in front of each device command, with an online check before the output changes.
Trigger
Webhook received
Notis starts this workflow when an external tool or custom backend sends an HTTP request.
Action
Bolt IoT Digital Write
Why this helps
Manual device commands can be delayed or sent without first confirming that the device is reachable.
- Start the action only from an explicit request.
- Check online status before issuing the digital write.
- Keep the requested pin state and run report in one workflow.
Setup
Build it in a few focused steps.
- 1Connect AnyDB and Bolt IoT once in the Notis portal.
- 2Create an automation from any channel or Automations, New Automation in the portal.
- 3Tell Notis: when a request names a Bolt device, pin, and HIGH or LOW state, check online and set that pin to the requested state only if the device is online.
- 4Choose the notis_webhook trigger and select where run reports should go.
- 5Test with one real request and a safe device output.
Questions about this workflow
Can the workflow choose a state on its own?
The prompt should require an explicit HIGH or LOW instruction in the request. The automation should not infer a state.
What does the online check do?
It verifies device connectivity before the digital write is sent.
When this happens · Trigger
Do this · Action
Supported Triggers and Actions
Notis builds workflows that link AnyDB to Bolt iot. A trigger fires from one place; an action lands in another.
AnyDB triggers
Bolt iot actions
Recurring trigger
Notis starts this workflow on a schedule, such as daily, weekly, or during business hours.
Analog Read
Reads the analog value from a device pin.
Webhook trigger
Notis starts this workflow when an external tool or custom backend sends an HTTP request.
Check Bolt device online status
Checks whether a device is online.
Bolt IoT Digital Write
Sets a device’s digital pin to HIGH or LOW.
Bolt IoT Serial Read
Reads incoming serial data from a device.
Bolt IoT Serial Write
Sends serial data to a device.
Bolt IoT Serial Write & Read
Sends serial data to a device and reads its reply.
Connect any two apps with Notis in the middle.
AnyDB and Bolt iot, or any other combination from 1,000+ integrations.
When this happens · Trigger
Do this · Action
Save your first hour today.
7-day trial of any paid plan, with 20$ of usage included.
No card. Works with personal or business Bolt iot.