Choose a Bolt pin state from a scheduled web result
Translate a page condition into the HIGH or LOW output state you specify for Bolt IoT.
Trigger
Recurring schedule
Notis starts this workflow on a schedule, such as daily, weekly, or during business hours.
Action
Bolt IoT Digital Write
Sets a device’s digital pin to HIGH or LOW.
Why this helps
Repeatedly checking a page and deciding which device state to set takes attention away from the work that depends on it.
- Connects a defined page condition to an explicit pin state.
- Makes the chosen HIGH or LOW state clear in the prompt.
- Reports the outcome for later review.
Setup
Build it in a few focused steps.
- 1Connect Airtop and Bolt IoT once in the Notis portal.
- 2Create an automation in Automations, New Automation.
- 3Describe the page condition and whether the specified Bolt pin should be HIGH or LOW.
- 4Pick a recurring schedule and choose where run reports go.
- 5Test with one real page condition and a safe device setup.
Questions about this workflow
What does this action control?
It sets a digital pin on the specified Bolt device HIGH or LOW. Use the state appropriate for your device.
Can I use it to toggle the pin?
Specify the desired state based on the current page result. Do not assume toggle behavior or state history unless you provide that information.
When this happens · Trigger
Do this · Action
Supported Triggers and Actions
Notis builds workflows that link Airtop to Bolt iot. A trigger fires from one place; an action lands in another.
Airtop triggers
Bolt iot actions
Recurring trigger
Notis starts this workflow on a schedule, such as daily, weekly, or during business hours.
Analog Read
Reads the analog value from a device pin.
Webhook trigger
Notis starts this workflow when an external tool or custom backend sends an HTTP request.
Check Bolt device online status
Checks whether a device is online.
Bolt IoT Digital Write
Sets a device’s digital pin to HIGH or LOW.
Bolt IoT Serial Read
Reads incoming serial data from a device.
Bolt IoT Serial Write
Sends serial data to a device.
Bolt IoT Serial Write & Read
Sends serial data to a device and reads its reply.
Connect any two apps with Notis in the middle.
Airtop and Bolt iot, or any other combination from 1,000+ integrations.
When this happens · Trigger
Do this · Action
Save your first hour today.
7-day trial of any paid plan, with 20$ of usage included.
No card. Works with personal or business Bolt iot.