Route a campaign signal to a device that listens over UART
When a campaign signal arrives at your Notis webhook, send your chosen ASCII message to a UART-ready Bolt device.
Trigger
Webhook received
Notis starts this workflow when an external tool or custom backend sends an HTTP request.
Action
Bolt IoT Serial Write
Sends serial data to a device.
Why this helps
Campaign signals may need to reach a device or local system that listens over serial, adding manual relay work.
- Relay a supplied campaign signal to a UART-connected device.
- Use the ASCII message format your receiving setup expects.
- Avoid manually copying a signal into another tool.
Setup
Build it in a few focused steps.
- 1Connect AimTell and Bolt IoT once in the Notis portal.
- 2Create an automation describing the webhook signal and the ASCII message to send over UART.
- 3Choose a Notis webhook as the trigger.
- 4Choose where Notis should send run reports.
- 5Test with one real signal and a Bolt device with UART initialized and ready.
Questions about this workflow
Does this initialize UART on the Bolt device?
No. The serial write action requires UART to be initialized and ready on the device.
Does the webhook come directly from an AimTell event?
No AimTell trigger event is listed for this workflow. A request to the Notis webhook starts it, and the request must include the signal.
When this happens · Trigger
Do this · Action
Supported Triggers and Actions
Notis builds workflows that link AimTell to Bolt iot. A trigger fires from one place; an action lands in another.
AimTell triggers
Bolt iot actions
Recurring trigger
Notis starts this workflow on a schedule, such as daily, weekly, or during business hours.
Analog Read
Reads the analog value from a device pin.
Webhook trigger
Notis starts this workflow when an external tool or custom backend sends an HTTP request.
Check Bolt device online status
Checks whether a device is online.
Bolt IoT Digital Write
Sets a device’s digital pin to HIGH or LOW.
Bolt IoT Serial Read
Reads incoming serial data from a device.
Bolt IoT Serial Write
Sends serial data to a device.
Bolt IoT Serial Write & Read
Sends serial data to a device and reads its reply.
Connect any two apps with Notis in the middle.
AimTell and Bolt iot, or any other combination from 1,000+ integrations.
When this happens · Trigger
Do this · Action
Save your first hour today.
7-day trial of any paid plan, with 20$ of usage included.
No card. Works with personal or business Bolt iot.