Send a campaign related device command and see its reply
Start with a webhook signal, send a command over UART, and keep the device response with the run report.
Trigger
Webhook received
Notis starts this workflow when an external tool or custom backend sends an HTTP request.
Action
Bolt IoT Serial Write & Read
Sends serial data to a device and reads its reply.
Why this helps
Sending a device command and checking its response separately creates another follow-up step and another place to lose context.
- Keep a command and its immediate reply in one run.
- Use a campaign signal to start the device interaction.
- Reduce manual follow-up after sending a serial command.
Setup
Build it in a few focused steps.
- 1Connect AimTell and Bolt IoT once in the Notis portal.
- 2Create an automation specifying the webhook condition, ASCII command, and reply handling.
- 3Choose a Notis webhook as the trigger.
- 4Choose where Notis should send run reports.
- 5Test with one real signal and a Bolt device with UART initialized and ready.
Questions about this workflow
Does this read later serial data?
No. It sends the specified ASCII command and captures the immediate response returned by the serial action.
What starts the automation?
A request to the Notis webhook starts it. AimTell does not have a listed native trigger event here.
When this happens · Trigger
Do this · Action
Supported Triggers and Actions
Notis builds workflows that link AimTell to Bolt iot. A trigger fires from one place; an action lands in another.
AimTell triggers
Bolt iot actions
Recurring trigger
Notis starts this workflow on a schedule, such as daily, weekly, or during business hours.
Analog Read
Reads the analog value from a device pin.
Webhook trigger
Notis starts this workflow when an external tool or custom backend sends an HTTP request.
Check Bolt device online status
Checks whether a device is online.
Bolt IoT Digital Write
Sets a device’s digital pin to HIGH or LOW.
Bolt IoT Serial Read
Reads incoming serial data from a device.
Bolt IoT Serial Write
Sends serial data to a device.
Bolt IoT Serial Write & Read
Sends serial data to a device and reads its reply.
Connect any two apps with Notis in the middle.
AimTell and Bolt iot, or any other combination from 1,000+ integrations.
When this happens · Trigger
Do this · Action
Save your first hour today.
7-day trial of any paid plan, with 20$ of usage included.
No card. Works with personal or business Bolt iot.