Clear the studio signal when a creative run ends
Let the end of a production run clear the device signal without another manual follow-up.
Trigger
Webhook received
Notis starts this workflow when an external tool or custom backend sends an HTTP request.
Action
Bolt IoT Digital Write
Why this helps
A readiness light or actuator can remain on after a run if nobody remembers to reset it.
- Clear a specified digital output when a finish request arrives.
- Confirm the device is online before sending the command.
- Reduce forgotten device resets between creative runs.
Setup
Build it in a few focused steps.
- 1Connect Abyssale and Bolt IoT once in the Notis portal.
- 2Create an automation for clearing the studio signal.
- 3Tell Notis which device and digital pin to set low after the run-finished request.
- 4Choose a webhook trigger and where run reports should go.
- 5Send one real finish request and verify the pin state.
Questions about this workflow
Can Notis detect that Abyssale has finished by itself?
No Abyssale trigger event is listed. An HTTP request must be sent to the Notis webhook when the run finishes.
What does setting the pin low do?
It sets the selected Bolt IoT digital output to low. The physical effect depends on the connected hardware.
When this happens · Trigger
Do this · Action
Supported Triggers and Actions
Notis builds workflows that link Abyssale to Bolt iot. A trigger fires from one place; an action lands in another.
Abyssale triggers
Bolt iot actions
Recurring trigger
Notis starts this workflow on a schedule, such as daily, weekly, or during business hours.
Analog Read
Reads the analog value from a device pin.
Webhook trigger
Notis starts this workflow when an external tool or custom backend sends an HTTP request.
Check Bolt device online status
Checks whether a device is online.
Bolt IoT Digital Write
Sets a device’s digital pin to HIGH or LOW.
Bolt IoT Serial Read
Reads incoming serial data from a device.
Bolt IoT Serial Write
Sends serial data to a device.
Bolt IoT Serial Write & Read
Sends serial data to a device and reads its reply.
Connect any two apps with Notis in the middle.
Abyssale and Bolt iot, or any other combination from 1,000+ integrations.
When this happens · Trigger
Do this · Action
Save your first hour today.
7-day trial of any paid plan, with 20$ of usage included.
No card. Works with personal or business Bolt iot.