Gate a device signal on a valid contact
Use a single incoming request to validate an email first, then send the requested digital output when your instruction's rule is satisfied.
Trigger
Webhook received
Notis starts this workflow when an external tool or custom backend sends an HTTP request.
Action
Bolt IoT Digital Write
Why this helps
Manual checks between an incoming request and a device command add delay and make it easier to act on incomplete contact details.
- Assess a contact email before a device command.
- Use a clear validation rule in the automation prompt.
- Record the validation and command outcome in the run report.
Setup
Build it in a few focused steps.
- 1Connect Abstract and Bolt IoT once in the Notis portal.
- 2Create an automation in Automations, New Automation, and give it a name and prompt.
- 3Tell Notis to validate the incoming email with Abstract and set the specified Bolt digital pin high or low only when your stated rule is met.
- 4Choose the webhook trigger and select where run reports should go.
- 5Test with one real request and a safe device output.
Questions about this workflow
Can the workflow choose which pin and output state to use?
Include the Bolt device ID, digital pin, desired high or low state, and the validation condition in your instruction or incoming request.
Does the email validation action itself control Bolt?
No. Abstract validates the email; the Bolt digital write action sets the specified pin when the instruction's condition is met.
When this happens · Trigger
Do this · Action
Supported Triggers and Actions
Notis builds workflows that link Abstract to Bolt iot. A trigger fires from one place; an action lands in another.
Abstract triggers
Bolt iot actions
Recurring trigger
Notis starts this workflow on a schedule, such as daily, weekly, or during business hours.
Analog Read
Reads the analog value from a device pin.
Webhook trigger
Notis starts this workflow when an external tool or custom backend sends an HTTP request.
Check Bolt device online status
Checks whether a device is online.
Bolt IoT Digital Write
Bolt IoT Serial Read
Reads incoming serial data from a device.
Bolt IoT Serial Write
Sends serial data to a device.
Bolt IoT Serial Write & Read
Sends serial data to a device and reads its reply.
Connect any two apps with Notis in the middle.
Abstract and Bolt iot, or any other combination from 1,000+ integrations.
When this happens · Trigger
Do this · Action
Save your first hour today.
7-day trial of any paid plan, with 20$ of usage included.
No card. Works with personal or business Bolt iot.