Push a Bolt configuration line
Make approved device updates repeatable and easy to request.
Trigger
Webhook received
Notis starts this workflow when an external tool or custom backend sends an HTTP request.
Action
Bolt IoT Serial Write
Tool to send serial data to a bolt device. use when you need to transmit ascii data over uart after initializing uart with serialbegin.
Why this helps
Configuration changes are error prone when commands live in scattered notes or chat messages.
- Standardizes configuration requests
- Reduces command copy errors
- Keeps a concise change report
Setup
Build it in a few focused steps.
- 1Connect 0CodeKit and Bolt iot in Notis once.
- 2Create an automation instructing Notis to send the approved ASCII configuration line to the Bolt device.
- 3Choose the webhook trigger.
- 4Choose where run reports should go.
- 5Test with one safe configuration line.
Questions about this workflow
Can this validate the new setting?
The serial write only sends the line; use a write and read workflow when the device returns confirmation.
Is the configuration line stored by Notis?
It is part of your automation instruction, so avoid including secrets.
When this happens · Trigger
Do this · Action
Supported Triggers and Actions
Notis builds workflows that link 0CodeKit to Bolt iot. A trigger fires from one place; an action lands in another.
0CodeKit triggers
Bolt iot actions
Recurring trigger
Notis starts this workflow on a schedule, such as daily, weekly, or during business hours.
Analog Read
Tool to read the analog value from a specified pin on a bolt device. use when you need sensor readings (0–1023) after confirming the device is online.
Webhook trigger
Notis starts this workflow when an external tool or custom backend sends an HTTP request.
Bolt IoT Digital Write
Tool to set a digital pin high or low on a specified bolt device. use when controlling actuators or leds via digital output.
Check Bolt device online status
Tool to check whether a specified bolt device is online. use when you need to verify device connectivity before sending commands (e.g., control signals). example: 'check if device bolt1234567 is online.'
Bolt IoT Digital Write
Tool to set a digital pin high or low on a specified bolt device. use when controlling actuators or leds via digital output.
Bolt IoT Serial Read
Tool to read incoming serial data from a bolt device. use when you've initialized uart with serialbegin and need to retrieve serial data.
Bolt IoT Serial Write
Tool to send serial data to a bolt device. use when you need to transmit ascii data over uart after initializing uart with serialbegin.
Bolt IoT Serial Write & Read
Tool to send serial data and read the response on a bolt device. use when you need to transmit ascii data over uart and capture its reply immediately.
Connect any two apps with Notis in the middle.
0CodeKit and Bolt iot, or any other combination from 1,000+ integrations.
When this happens · Trigger
Do this · Action
Save your first hour today.
7-day trial of any paid plan, with 20$ of usage included.
No card. Works with personal or business Bolt iot.